Link environmental hazards to essential services
Map the equipment and facilities supporting regulated services, including local communications rooms, operational technology sites and offsite backup locations. Identify where a single power or cooling failure could affect availability, integrity or recovery.
Article 21(1) addresses risks to network and information systems and their physical environment. It is not a universal specification for room temperature, generator capacity or facility design. Apply the Directive alongside relevant national law and any sector rules.
Assess power and climate dependencies
Review utility feeds, uninterrupted power supplies, generators, cooling systems and their maintenance arrangements where critical systems rely on them. Consider how long protection lasts and whether the intended service can operate throughout an outage.
A battery backup may keep computers running while cooling, connectivity or access-control equipment fails. Evaluate connected dependencies instead of treating an individual component's rated uptime as a guarantee of continuity.
Protect against water, fire and local conditions
Identify exposure from plumbing, flooding, smoke, fire and site-specific hazards. Choose appropriate detection and suppression measures for the equipment and personnel involved, coordinating with building operators and emergency plans.
Physical controls should not introduce unmanaged risks to staff or services. Where a third party operates the facility, confirm responsibilities for maintenance, alarms and response rather than presuming all protections are included in a lease.
Define response procedures and ownership
Assign staff to receive alerts, contact facility operators, protect equipment and coordinate continuity actions. Document safe shutdown and restoration dependencies, including access to recovery records during a site outage.
Test realistic scenarios and make sure after-hours escalation works. An alert visible only to a daytime facilities team may not provide useful protection for an around-the-clock service.
Gather evidence and correct gaps
Retain inspection results, maintenance records, alarm test results, exercise outcomes and important supplier assurances. Record what was actually tested, any exclusions, the affected services and corrective-action owners.
Review controls following outages, building changes or expanded system loads. Verify the correction rather than marking a finding closed when a work order is issued.
Points of clarification
Does NIS2 prescribe the same technical configuration for every covered organisation?
No. Appropriate measures depend on identified risk, relevant services, Member State law and any applicable sector-specific requirements.
Can a policy alone prove that a technical control works?
No. Relevant implementation records and effectiveness assessments provide stronger assurance.